The joint can hold pump and motor dead weight.

Can withstand the pressure developed by the pump.

Can withstand the reverse thrust created during pumping.

Can withstand the water hammer effect during ″start / stop″ of the pump

Can withstand the TORQUE developed during ″start & stop″ of the pump.

Is corrosion free, being made of specific PVC compound.

Installation Is made easy due to its light weight.

Being thermoplastic, very smooth inner bore with ″C″ value of about 150 against 100 of Gl pipes, so the frictional loss is kept at the minimum possible level.

Due to very smooth inner bore of pipe (with ″C″ value 150) which remains the same throughout its service life as it is inert to corrosive nature of water, the friction head loss on the pump is constant and at minimum level. This reduces energy consumption Due to above advantages, the system becomes energy efficient and pays for its cost out of the savings during its service life.

Always refer the pipe selection chart for correct pipe selection.

The Jain Thread Loc Plus™ Column Pipe should be used in tube wells where the diameter of the tube well is at least two inches more than the diameter of the pump.

If the pump does not have open discharge at the well head, another Non Return Valve should be installed at the well head between top connector and system to be connected.

Use double split clamps to hold the column pipe at the well head.

Always mount the split clamp on pipe, below the coupler

Use plain water or soap solution to lubricate the rubber ring and the spigot end of the pipe.

Store the pipes under shade and on level ground in ventilated space.

During installation, ensure that the rubber ring is at its place in the coupler.

 Always use the standard fittings supplied by the company.

Do not install the pump without the non return valve in the pump.

Do not use any grease or lubricant other than the one recommended during assembly.

Do not use pipes with damaged / scratched ends as such a joint may leak or fail.

Do not disturb the factory fitted assembly of pump connector.

Do not remove the coupler by holding the pipe alone in the split clamp.

Do not use any tool to lock or unlock the pipe.